Hello, about 2 months ago i decided to update my rgh falcon to the newest 14719 firmware for both the ggbuild on the cygnos nand, and stock on the stock nand. so i used the cygnos usb programmer and toolbox to flash the images to both the cygnos nand and the stock nand, everything worked fine on the cygnos side but the stock nand no longer would boot (not even a green light, nothing). i didnt feel like fixing it then because it wasnt a problem for me yet. but just recently decided to flash my dvd drive's firmware so i could run backups, while i had the xbox open i figured i would flash a new image to the stock nand with the nand x. so i generated an image and flashed it, went to turn on the xbox and the green light went on, about 20 second later it gave RROD with 2nd error code 0022, which from past idiocy i have learned its something wrong with the LDV. so i checked the image with flash tool and it said 16 for the LDV, i went to the xbox to try and boot the cygnos nand with eject to get into xell reloaded, the green light lit up but nothing happeded. i looked at the coolrunner when i tried it a second time and noticed it wasnt glitching (i cant boot into regular ggbuild either) so i unplugged the xbox waited a min and plugged it back in. i tryed to boot into cygnos nand (not realizing it was in bootloader mode) and nothing happed (as expected) but just for the hell of it i tried booting with eject while still in bootloader mode and it actually booted xell. the fuse count is still 16. now i'm a little confused, why is the coolrunner glitching only when the cygnos is in bootloader mode? why cant i boot stock? what am i missing? (as a note i have a relay installed to turn off the coolrunner when the cygnos shuts off). could it possibly be a cold soder joint somewhere? (also i flashed the drive first, and tested it before i tried flashing the nands, it worked on the ggbuild cygnos nand, booted and everything. the problem arose when i flashed the stock nand using the nand x) (also i just thought of this but could it be that i accidently left the cygnos on when flashing the nand with the nand x and it somehow messed something up? i dont think i did but its always possible) Thanks for your help!
